From: Richard Davidson (rich@myhomemail.net)
Date: Tue Feb 10 2004 - 12:34:45 GMT-3
You should bye the ATM learning lab from bradshaw.
see coment below.
>svc ToR9 nsap
47.00918100000000E01E6C4901.999999999999.99
> protocol ip 10.10.10.9
> encapsulation aal5snap
>!
>atm esi-address 666666666666.66 <-- "66 should be 00"
>!
>router isis
>net 49.0001.6666.6666.6666.00 <-- "this has no
relation to the esi for atm."
>is-type level-2-only
--- chee-beng lim <dundeeking@hotmail.com> wrote:
> Ian,
>
> I am using ipexpert rack for ATM testing; I don't
> have access to the ATM
> switch.
>
> I have tested pvc using pt-to-pt/multipoint and
> running ISIS a/c them with
> no problem.
>
> Am I right to say that SVC availability to the
> router R6 and R9 dependent on
> how the ATM switch is being configured (forgive my
> ignornance on the limited
> ATM knowledge).
>
> Thanks for your response.
>
>
>
>
>
> >From: "Ian Stong" <istong@stong.org>
> >Reply-To: "Ian Stong" <istong@stong.org>
> >To: "'chee-beng lim'" <dundeeking@hotmail.com>,
> <ccielab@groupstudy.com>
> >Subject: RE: Setting up svc in ATM a/c R6 and R9
> (svc not showing up)
> >Date: Mon, 9 Feb 2004 20:17:06 -0500
> >
> >HI,
> >
> >Couple of questions for you:
> >
> >Is the ATM switch configured for the SVC's (do you
> have the switch
> >config)?
> >
> >Any reason why you don't have broadcast on R6?
> >
> >What's the reason behind doing multipoint versus
> point to point?
> >
> >
> >Thanks,
> >
> >Ian
> >www.ccie4u.com
> >Rack Rentals and Lab Scenarios starting at $20
> >
> >
> >-----Original Message-----
> >From: nobody@groupstudy.com
> [mailto:nobody@groupstudy.com] On Behalf Of
> >chee-beng lim
> >Sent: Monday, February 09, 2004 7:55 PM
> >To: ccielab@groupstudy.com
> >Subject: Setting up svc in ATM a/c R6 and R9 (svc
> not showing up)
> >
> >Having problem in setting up svc between R6 and R9
> as follow:
> >
> >R6:
> >R6#sh run | b ATM
> >interface ATM0
> >no ip address
> >pvc 0/5 qsaal
> >!
> >pvc 0/16 ilmi
> >!
> >no atm ilmi-keepalive
> >!
> >interface ATM0.1 multipoint
> >ip address 10.10.10.6 255.255.255.0
> >!
> >svc ToR9 nsap
> 47.00918100000000E01E6C4901.999999999999.99
> > protocol ip 10.10.10.9
> > encapsulation aal5snap
> >!
> >atm esi-address 666666666666.66
> >!
> >router isis
> >net 49.0001.6666.6666.6666.00
> >is-type level-2-only
> >
> >R6#sh atm ilmi-status
> >
> >Interface : ATM0 Interface Type : Private UNI
> (User-side)
> >ILMI VCC : (0, 16) ILMI Keepalive : Disabled
> >ILMI State: UpAndNormal
> >Peer IP Addr: 0.0.0.0 Peer IF Name:
> ATM0/0/2
> >Peer MaxVPIbits: 8 Peer MaxVCIbits:
> 14
> >Active Prefix(s) :
> >47.0091.8100.0000.00e0.1e6c.4901
> >R6#sh atm map
> >Map list ToR9_ATM0.1 : PERMANENT
> >ip 10.10.10.9 maps to NSAP
> 47.00918100000000E01E6C4901.999999999999.99
> >
> >R6#sh atm vc
> > VCD /
> Peak Avg/Min
> >Burst
> >Interface Name VPI VCI Type Encaps
> SC Kbps Kbps
> >Cells
> >Sts
> >0 1 0 5 PVC SAAL
> UBR 155000
> > UP
> >0 2 0 16 PVC ILMI
> UBR 155000
> > UP
> >R6#
> >
> >
> >========
> >R9:
> >interface ATM3/0
> >no ip address
> >no atm ilmi-keepalive
> >pvc 0/5 qsaal
> >!
> >pvc 0/16 ilmi
> >!
> >!
> >interface ATM3/0.1 multipoint
> >ip address 10.10.10.9 255.255.255.0
> >atm esi-address 999999999999.99
> >!
> >svc ToR6 nsap
> 47.00918100000000E01E6C4901.666666666666.66
> > protocol ip 10.10.10.6
> > broadcast
> > encapsulation aal5snap
> >!
> >
> >router isis
> >net 49.0001.9999.9999.9999.00
> >is-type level-2-only
> >log-adjacency-changes
> >
> >R9#sh atm map
> >Map list ToR6_ATM3/0.1 : PERMANENT
> >ip 10.10.10.6 maps to NSAP
> 47.00918100000000E01E6C4901.666666666666.66
> > , broadcast
> >
> >R9#sh atm ilmi-status
> >
> >Interface : ATM3/0 Interface Type : Private UNI
> (User-side)
> >ILMI VCC : (0, 16) ILMI Keepalive : Disabled
> >ILMI State: UpAndNormal
> >Peer IP Addr: 0.0.0.0 Peer IF Name:
> ATM0/0/3
> >Peer MaxVPIbits: 8 Peer MaxVCIbits:
> 14
> >Active Prefix(s) :
> >47.0091.8100.0000.00e0.1e6c.4901
> >R9#sh atm vc
> > VCD /
> Peak Avg/Min
> >Burst
> >Interface Name VPI VCI Type Encaps
> SC Kbps Kbps
> >Cells
> >Sts
> >3/0 1 0 5 PVC SAAL
> UBR 155000
> > UP
> >3/0 2 0 16 PVC ILMI
> UBR 155000
> > UP
> >R9#
> >
> >
> >
> >====> trying debug commands on the R6 with
> output====
> >R6>enable
> >R6#show debug
> >Generic ATM Signalling:
> > ATM Signalling Events debugging is on
> >ATM0 ATM Signalling Event debugging is on
> >R6#ping 10.10.10.9
> >
> >Type escape sequence to abort.
> >Sending 5, 100-byte ICMP Echos to 10.10.10.9,
> timeout is 2 seconds:
> >.....
> >Success rate is 0 percent (0/5)
> >R6#debug ip packet
> >IP packet debugging is on
> >R6#ping 10.10.10.9
> >
> >Type escape sequence to abort.
> >Sending 5, 100-byte ICMP Echos to 10.10.10.9,
> timeout is 2 seconds:
> >
> >*Feb 9 18:40:24 UTC: IP: s=10.10.10.6 (local),
> d=10.10.10.9 (ATM0.1),
> >len
> >100,g
> >*Feb 9 18:40:24 UTC: IP: s=10.10.10.6 (local),
> d=10.10.10.9 (ATM0.1),
> >len
> >100,.
> >*Feb 9 18:40:26 UTC: IP: s=10.10.10.6 (local),
> d=10.10.10.9 (ATM0.1),
> >len
> >100,g
> >*Feb 9 18:40:26 UTC: IP: s=10.10.10.6 (local),
> d=10.10.10.9 (ATM0.1),
> >len
> >100,.
> >*Feb 9 18:40:28 UTC: IP: s=10.10.10.6 (local),
> d=10.10.10.9 (ATM0.1),
> >len
> >100,g
> >*Feb 9 18:40:28 UTC: IP: s=10.10.10.6 (local),
> d=10.10.10.9 (ATM0.1),
> >len
> >100,.
> >*Feb 9 18:40:30 UTC: IP: s=10.10.10.6 (local),
> d=10.10.10.9 (ATM0.1),
> >len
> >100,g
> >*Feb 9 18:40:30 UTC: IP: s=10.10.10.6 (local),
> d=10.10.10.9 (ATM0.1),
> >len
> >100,.
> >*Feb 9 18:40:32 UTC: IP: s=10.10.10.6 (local),
> d=10.10.10.9 (ATM0.1),
> >len
> >100,g
> >*Feb 9 18:40:32 UTC: IP: s=10.10.10.6 (local),
> d=10.10.10.9 (ATM0.1),
> >len
> >100,.
> >Success rate is 0 percent (0/5)
> >R6#
> >
> >
> >Note: not seeing anything useful in R6 with "debug
> atm sig-event" when
> >doing
> >ping to R9
> >
>
>_________________________________________________________________
> >Download games, logos, wallpapers and lots more at
> MSN Mobile!
> >http://www.msn.com.sg/mobile/
> >
>
>_______________________________________________________________________
> >Please help support GroupStudy by purchasing your
> study materials from:
> >http://shop.groupstudy.com
> >
> >Subscription information may be found at:
> >http://www.groupstudy.com/list/CCIELab.html
> >
>
>_______________________________________________________________________
> >Please help support GroupStudy by purchasing your
> study materials from:
> >http://shop.groupstudy.com
> >
> >Subscription information may be found at:
> >http://www.groupstudy.com/list/CCIELab.html
>
>
This archive was generated by hypermail 2.1.4 : Fri Mar 05 2004 - 07:13:48 GMT-3