Etherswitch Network Module

From: ccielab@cox.net
Date: Mon Jan 26 2004 - 23:51:39 GMT-3

• Next message: Peter van Oene: "Re: MPLS on the R&S lab"
• Previous message: Mike Williams: "RE: 4507R switch question"
• Next in thread: Richard L. Pickard: "RE: Etherswitch Network Module"
• Maybe reply: Richard L. Pickard: "RE: Etherswitch Network Module"
• Maybe reply: Todd Veillette: "Re: Etherswitch Network Module"
• Maybe reply: Frank Jimenez: "RE: Etherswitch Network Module"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

is anyone using these in their 2600/3600 cisco routers. I have several with later than the 12.2.8T sw that is specified, but I cannot get the routed ports to work.
On a fast ethernet interface, I type no switchport and get something like "cannot configure L3 links...". Does anyone know how to enable a routed port on the switchport module?

Thanks

• Next message: Peter van Oene: "Re: MPLS on the R&S lab"
• Previous message: Mike Williams: "RE: 4507R switch question"
• Next in thread: Richard L. Pickard: "RE: Etherswitch Network Module"
• Maybe reply: Richard L. Pickard: "RE: Etherswitch Network Module"
• Maybe reply: Todd Veillette: "Re: Etherswitch Network Module"
• Maybe reply: Frank Jimenez: "RE: Etherswitch Network Module"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Mon Feb 02 2004 - 09:07:51 GMT-3