From: Jonathan Hays (nomad@gfoyle.org)
Date: Mon Jan 26 2004 - 18:50:48 GMT-3
you wrote:
>-----Original Message-----
>From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On
>Behalf Of Georg Pauwen
>Sent: Monday, January 26, 2004 3:45 PM
>To: RajUppal@mrgmail.com; ccielab@groupstudy.com
>Subject: RE: 802.1Q Multi Site Vlan
>
>
>Hello Raj,
>
>AFAIK, the 3550 has the command:
>
>switchport multi vlan
>
>which allows you to configure a list of VLANs to which the port is
>associated. Check this link for the command syntax:
>
>http://www.cisco.com/univercd/cc/td/doc/product/lan/c2900xl/29_
>35wc6/cli/clicmds.htm#56647
>
>Regards,
>
>Georg
= = =
Sorry, but that command is NOT available on the 3550.
Below is a session from a 3550 with the EMI image:
CAT1#conf t
Enter configuration commands, one per line. End with CNTL/Z.
CAT1(config)#int fa0/1
CAT1(config-if)#switchport ?
access Set access mode characteristics of the interface
block Disable forwarding of unknown uni/multi cast addresses
broadcast Set broadcast suppression level on this interface
host Set port host
mode Set trunking mode of the interface
multicast Set multicast suppression level on this interface
nonegotiate Device will not engage in negotiation protocol on this
interface
port-security Security related command
priority Set appliance 802.1p priority
protected Configure an interface to be a protected port
trunk Set trunking characteristics of the interface
unicast Set unicast suppression level on this interface
voice Voice appliance attributes
<cr>
CAT1(config-if)#switchport
CAT1(config-if)#end
CAT1#
*Apr 11 05:47:42.054: %SYS-5-CONFIG_I: Configured from console by
console
CAT1#sh ver | i IOS
IOS (tm) C3550 Software (C3550-I5K2L2Q3-M), Version 12.1(14)EA1a,
RELEASE SOFTWARE (fc1)
CAT1#
This archive was generated by hypermail 2.1.4 : Mon Feb 02 2004 - 09:07:50 GMT-3