RE: how to set circuit weight of DLSw load balance

From: Scott Morris (swm@emanon.com)
Date: Mon Jan 05 2004 - 12:27:48 GMT-3

• Next message: Marvin Greenlee: "RE: Router blew a gasket"
• Previous message: Scott Morris: "RE: Broadcast to Multicast (ip multicast helper-map broadcast)"
• Maybe in reply to: Xue Fei: "how to set circuit weight of DLSw load balance"
• Next in thread: Alec: "Re: how to set circuit weight of DLSw load balance"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

As a note, 6 is only two times the weight of 3. :)

Scott

-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of Xue
Fei
Sent: Monday, January 05, 2004 9:59 AM
To: ccielab@groupstudy.com
Subject: how to set circuit weight of DLSw load balance

Hi guys,

I check Document CD about that, but still no very clear...
If I want traffic over link to remote-peer 10.1.1.1 three times of traffic
to remote-peer 10.2.2.2, is that configuration right?
Default circuit-weight is 3.
 
dlsw load-balance circuit-count 3
dlsw remote-peer 0 tcp 10.2.2.2 circuit-weight 3 dlsw remote-peer 0 tcp
10.1.1.1 circuit-weight 6

Thanks!

Xue Fei
xuefei@bgctv.com.cn
2004-01-05

• Next message: Marvin Greenlee: "RE: Router blew a gasket"
• Previous message: Scott Morris: "RE: Broadcast to Multicast (ip multicast helper-map broadcast)"
• Maybe in reply to: Xue Fei: "how to set circuit weight of DLSw load balance"
• Next in thread: Alec: "Re: how to set circuit weight of DLSw load balance"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Mon Feb 02 2004 - 09:07:36 GMT-3