From: Phil (ciscostudent1@yahoo.com.br)
Date: Sun Dec 07 2003 - 17:56:16 GMT-3
Luke,
Notice, also that the NM-1CT1 does not have a internal CSU. You will need to connect it to a CSU and the CSU to the Adtran Simulator.
Phil
Luke <ccie@luke.ca> wrote:
Thanks Phil, but I have a DB-15 connector on the Cisco side (see below).
I'm sure it has been done, just not clear on which cable to buy.
Luke
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Phil
Sent: December 6, 2003 6:46 PM
To: Luke; ccielab@groupstudy.com
Subject: Re: Cable for ISDN PRI/T1 (NM-1CT1) to Adtran Simulator
You can use a regular RJ-45 ethernet cable:
http://www.cisco.com/en/US/products/hw/modules/ps2797/products_tech_note
09186a00800a4d67.shtml
Luke wrote:
I have a 2600 series router that I need to connect to an Adtran 550 ISDN
simulator.
Cisco end: NM-1CT1 (ISDN PRI/T1) with DB-15F
Adtran end: RJ-48 socket
Anybody done this? What cable(s) did you use?
Thanks
Luke
This archive was generated by hypermail 2.1.4 : Sat Jan 03 2004 - 08:25:37 GMT-3