From: David Heaton (David.Heaton@citec.com.au)
Date: Thu Nov 27 2003 - 06:11:39 GMT-3
break on boot, then:
o/r 0x2142 - to change config register
i - to reset the box
should reload int boot helper with flash Read/Write
no routing will be available, so "ip default-gateway" is needed
this can also be done over a network:
provided, that your tftp server has a route to the WAN address,
and that the WAN is not ISDN (apparently),
and if FR, that frame-relay maps have been used
(as inverse arp won't work when the router is running on helper image)
if you wipe the IOS totally and end up in rommon>,
then you'll have to SET a few things, www.cisco.com
for TFTPDNLD etc.
Cheers
David
-----Original Message-----
From: Tom Young [mailto:gitsyoung@yahoo.co.jp]
Sent: Thursday, 27 November 2003 3:53 PM
To: ccielab@groupstudy.com
Subject: change the READ-ONLY flash setting
Hi, group
My router is too old, the flash is read-only, so I
couldn't change the ios from tftp, what the command could change the
status to read-write ?
thanks alot
This archive was generated by hypermail 2.1.4 : Fri Dec 12 2003 - 12:29:18 GMT-3