From: William Chen (kwchen@netvigator.com)
Date: Thu Nov 13 2003 - 07:09:47 GMT-3
Dear group,
I found the same setting works fine in FastEthernet router interface.
Best Regards,
William Chen
>
> 1H%s*L: William Chen <kwchen@netvigator.com>
> $i4A: 2003/11/13 ,P4A%| $U$H 06:05:02 GMT+08:00
> &,%s*L: <ccielab@groupstudy.com>
> %D&.: dot1q natvie vlan
>
> Dear all,
>
> I try to setup the router to use a native VLAN. Following is the setting:
>
> RouterA:
> interface Ethernet0/0.10
> encapsulation dot1Q 10 native
> ip address 192.168.10.1 255.255.255.0
> !
> interface Ethernet0/0.20
> encapsulation dot1Q 20
> ip address 192.168.20.1 255.255.255.0
> !
>
> SwitchA:
> interface FastEthernet0/1
> switchport trunk encapsulation dot1q
> switchport trunk native vlan 10
> switchport mode trunk
> no ip address
> end
> interface Vlan10
> ip address 192.168.10.20 255.255.255.0
> end
> interface Vlan20
> ip address 192.168.20.20 255.255.255.0
> end
>
> Then I run the following test:
> SwitchA#p 192.168.10.1
>
> Type escape sequence to abort.
> Sending 5, 100-byte ICMP Echos to 192.168.10.1, timeout is 2 seconds:
> .....
> Success rate is 0 percent (0/5)
> SwitchA#p 192.168.20.1
>
> Type escape sequence to abort.
> Sending 5, 100-byte ICMP Echos to 192.168.20.1, timeout is 2 seconds:
> !!!!!
> Success rate is 100 percent (5/5), round-trip min/avg/max = 1/2/4 ms
>
> Anything I am wrong?
>
> Best Regard,
> William Chen
>
> _______________________________________________________________________
> Please help support GroupStudy by purchasing your study materials from:
> http://shop.groupstudy.com
>
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
Best Regards,
William Chen
This archive was generated by hypermail 2.1.4 : Fri Dec 12 2003 - 12:29:11 GMT-3