From: Pun, Alec CL (Alec.CL.Pun@pccw.com)
Date: Tue Nov 04 2003 - 23:47:30 GMT-3
Yasser,
Thanks. If not set interface command, the default route will be generated
to ALL interface.
Then is that approach works for OSPF default-information originate also ?
regards,
alec
-----Original Message-----
From: Yasser Aly [mailto:blackyeyes00@hotmail.com]
Sent: Wednesday, November 05, 2003 6:15 AM
To: Pun, Alec CL; ccielab@groupstudy.com
Subject: Re: RIP default-information originate
Alec,
Using the set interface command will make the generated default-route to
be sourced out of this mentioned interface specifically. When u tried it
without the set interface command, was the default-route generated out of
this interface or another one ?
I guess if u have many interfaces it would be a nice practice to define
which one will generate the default-route
Regards,
Yasser
>From: "Pun, Alec CL" <Alec.CL.Pun@pccw.com>
>Reply-To: "Pun, Alec CL" <Alec.CL.Pun@pccw.com>
>To: Group Study <ccielab@groupstudy.com>
>Subject: RIP default-information originate
>Date: Tue, 4 Nov 2003 23:18:53 +0800
>
>What is the use of the set interface s1/0 command in the route-map used in
>RIP default-information orginate ?
>
>I tried one without the set interface s1/0 command but still can generate a
>default route based on the existence of a prefix in the routing table.
>
>regards,
>alec
>
>P.S. The following RIP example is copied from DocCD :
>
>router rip
> version 2
> network 172.68.16.0
> default-information originate route-map condition
>!
> route-map condition permit 10
> match ip address 10
> set interface s1/0
>!
>access-list 10 permit 172.68.16.0 0.0.0.255
>!
>
>_______________________________________________________________________
>Please help support GroupStudy by purchasing your study materials from:
>http://shop.groupstudy.com
>
>Subscription information may be found at:
>http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Fri Dec 12 2003 - 12:29:08 GMT-3