From: Jonathan V Hays (jhays@jtan.com)
Date: Fri Oct 17 2003 - 12:29:48 GMT-3
It is in the Command Reference for Voice. They state it twice under the
description for the "preference" command.
http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/
fvvfax_r/vrf_g.htm#1025549
preference
To indicate the preferred order of a dial peer within a hunt group, use
the preference command in dial-peer configuration mode. To remove the
preference value on the voice port, use the no form of this command.
preference value
no preference value
Syntax Description
value
An integer from 0 to 10, where the lower the number, the higher the
preference. The default value is 0 (highest preference).
Defaults
0 (highest preference)
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Vazman@aol.com
Sent: Friday, October 17, 2003 2:01 AM
To: ccielab@groupstudy.com
Subject: Voice preference default value
Hello,
Anyone knows what is the default preference for a dial peer? If you have
two dial peers with the same destination pattern and preference 1 and 2,
the dial peer with preference 1 will be used first.
But if you have two dial peers with, one with no preference set and the
other with a preference of 1, which one will be used? I could not find
it on the DocCD or in the archives and dont have voice in my lab to
test.
Thanks,
This archive was generated by hypermail 2.1.4 : Mon Nov 24 2003 - 07:53:04 GMT-3