From: Arifur Rahman (arahman@cisco.com)
Date: Sun Oct 12 2003 - 01:59:38 GMT-3
Hi Brian
Thank you for your response. My router is 7200. show ver, set of supported
command at pvc follows -
r7#sh ver
Cisco Internetwork Operating System Software
IOS (tm) 7200 Software (C7200-JO3S-M), Version 12.2(11)T1, RELEASE
SOFTWARE (fc2)
TAC Support: http://www.cisco.com/tac
Copyright (c) 1986-2002 by cisco Systems, Inc.
Compiled Sat 28-Sep-02 21:49 by ccai
Image text-base: 0x60008940, data-base: 0x61C38000
ROM: System Bootstrap, Version 11.1(13)CA, EARLY DEPLOYMENT RELEASE
SOFTWARE (fc1)
BOOTLDR: 7200 Software (C7200-BOOT-M), Version 12.0(2)XE2, EARLY DEPLOYMENT
RELEASE SOFTWARE (fc1)
r7 uptime is 3 hours, 34 minutes
System returned to ROM by reload at 06:20:50 UTC Sat Oct 11 2003
System image file is "tftp://12.7.36.252/c7200-jo3s-mz.122-11.T1"
cisco 7206 (NPE200) processor (revision B) with 114688K/16384K bytes of memory.
Processor board ID 15459614
R5000 CPU at 200Mhz, Implementation 35, Rev 2.1, 512KB L2 Cache
6 slot midplane, Version 1.3
Last reset from power-on
Bridging software.
X.25 software, Version 3.0.0.
SuperLAT software (copyright 1990 by Meridian Technology Corp).
TN3270 Emulation software.
8 Ethernet/IEEE 802.3 interface(s)
3 FastEthernet/IEEE 802.3 interface(s)
4 Serial network interface(s)
1 ATM network interface(s)
125K bytes of non-volatile configuration memory.
4096K bytes of packet SRAM memory.
20480K bytes of Flash PCMCIA card at slot 0 (Sector size 128K).
20480K bytes of Flash PCMCIA card at slot 1 (Sector size 128K).
4096K bytes of Flash internal SIMM (Sector size 256K).
Configuration register is 0x0
r7(config-if-atm-vc)#?
ATM virtual circuit configuration commands:
atm atm pvc commands
broadcast Pseudo-broadcast
class-vc Configure default vc-class name
default Set a command to its defaults
dialer set dialer pool this pvc belongs to
encapsulation Select ATM Encapsulation for VC
exit-vc Exit from ATM VC configuration mode
forwarding forwarding commands
ilmi Configure ILMI management
inarp Change the inverse arp timer on the PVC
ip addr inarp Assign an ip address to the atm interface through ATMInarp
no Negate a command or set its defaults
oam Configure oam parameters
oam-pvc Send oam cells on this pvc
pppoe PPPoE options
protocol Map an upper layer protocol to this connection.
ubr Configure Unspecified Bit Rate (UBR) for this interface
vcci VCC Identifier
r7(config-if-atm-vc)#^Z
r7#
03:37:28: %SYS-5-CONFIG_I: Configured from console by console
r7#sr int a5/0
Building configuration...
Current configuration : 130 bytes
!
interface ATM5/0
ip address 2.2.2.2 255.0.0.0
no ip route-cache
no ip mroute-cache
no atm ilmi-keepalive
pvc 0/32
!
end
thank you - Arif
At 09:27 PM 10/11/2003 -0500, Brian McGahan wrote:
>Arif,
>
> If you are not seeing these commands under your ATM interface
>the most likely reason is that your hardware does not support it. What
>platform and ATM module do you have?
>
>Brian McGahan, CCIE #8593
>bmcgahan@internetworkexpert.com
>
>Internetwork Expert, Inc.
>http://www.InternetworkExpert.com
>Toll Free: 877-224-8987
>Direct: 708-362-1418 (Outside the US and Canada)
>
>
> > -----Original Message-----
> > From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf
>Of
> > Arifur Rahman
> > Sent: Saturday, October 11, 2003 2:25 PM
> > To: ccielab@groupstudy.com
> > Subject: ios image that supports atm commands?
> >
> > Hi Group
> > I need some help -
> >
> > Does anyone know which IOS image support "abr", "ubr", "ubr+", "vbr"
>etc
> > commands? What is the way to find that?
> >
> > Appreciate your help.
> > thanks - Arif
> >
> > ***Get your CCIE and a FREE vacation: Shop.GroupStudy.com***
> >
>_______________________________________________________________________
> > Please help support GroupStudy by purchasing your study materials
>from:
> > shop.groupstudy.com
> >
> > Subscription information may be found at:
> > http://www.groupstudy.com/list/CCIELab.html
***Get your CCIE and a FREE vacation: Shop.GroupStudy.com***
This archive was generated by hypermail 2.1.4 : Mon Nov 24 2003 - 07:53:00 GMT-3