From: Tony Schaffran (groupstudy@cconlinelabs.com)
Date: Sat Oct 11 2003 - 14:13:49 GMT-3
A simple "show run" will show you what ports if they are not identified in
the workbook.
Tony Schaffran
Network Analyst
CCIE #11071
CCNP, CCNA, CCDA,
NNCDS, NNCSS, CNE, MCSE
www.cconlinelabs.com
Your #1 choice for online Cisco rack rentals.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
ccie2be
Sent: Saturday, October 11, 2003 7:24 AM
To: Group Study
Subject: Basic voice port question
Hi all,
When one or more voice ports need to be configured in the lab, we have to
know for the 2600 the following info:
Router(config)# voice-port slot/subunit/port
Does Cisco tell us what "slot/subunit/port" to use or do we need to use a
show
command to figure that out? What show command can be used to determine the
above info?
Thanks, dt
***Get your CCIE and a FREE vacation: Shop.GroupStudy.com***
This archive was generated by hypermail 2.1.4 : Mon Nov 24 2003 - 07:53:00 GMT-3