From: Ken.Farrington@barclayscapital.com
Date: Sun Oct 05 2003 - 11:52:46 GMT-3
R8#sh cont serial 0
QUICC Serial unit 0
idb at 0x2117970, driver data structure at 0x2119394
SCC Registers:
General [GSMR]=0x2:0x00000030, Protocol-specific [PSMR]=0x0
Events [SCCE]=0x0000, Mask [SCCM]=0x001F, Status [SCCS]=0x0006
Transmit on Demand [TODR]=0x0, Data Sync [DSR]=0x7E7E
Interrupt Registers:
Config [CICR]=0x00368461, Pending [CIPR]=0x00004202
Mask [CIMR]=0x50000850, In-srv [CISR]=0x00000000
Command register [CR]=0x600
Port A [PADIR]=0x10C4, [PAPAR]=0x3FF3
[PAODR]=0x0040, [PADAT]=0xF2EA
Port B [PBDIR]=0x00F13F, [PBPAR]=0x0010CE
[PBODR]=0x000000, [PBDAT]=0x0248DC
Port C [PCDIR]=0x0284, [PCPAR]=0x0800
[PCSO]=0x0030, [PCDAT]=0x0C0B, [PCINT]=0x0000
DCE V.11 (X.21) serial cable attached.
<============================================= Here
-----Original Message-----
From: Ken.Farrington@barclayscapital.com
[mailto:Ken.Farrington@barclayscapital.com]
Sent: 05 October 2003 15:46
To: clapun@graduate.hku.hk; ccielab@groupstudy.com
Subject: RE: back-to-back FR encapsulation
mate, just do a show cont (look for dce) and put the clock rate on the
other router.
u should see that it will work
-----Original Message-----
From: Alec [mailto:clapun@graduate.hku.hk]
Sent: 05 October 2003 15:38
To: Lab
Subject: back-to-back FR encapsulation
Hi group,
Are thery configuration samples that allow running FR encapsulation over
back-to-back serial cable. I tried to run in my Cisco 2500, but fails.
regards,
alec
interface Serial1
ip address 1.1.1.5 255.255.255.0
encapsulation frame-relay
frame-relay intf-type dce
end
R5#conf t
Enter configuration commands, one per line. End with CNTL/Z.
R5(config)#int s1
R5(config-if)#clock rate 64000
%Error: This command applies only to DCE interfaces
R5(config-if)#
***Get your CCIE and a FREE vacation: Shop.GroupStudy.com***
This archive was generated by hypermail 2.1.4 : Mon Nov 24 2003 - 07:52:57 GMT-3