From: Ken.Farrington@barclayscapital.com
Date: Sun Oct 05 2003 - 11:46:12 GMT-3
mate, just do a show cont (look for dce) and put the clock rate on the
other router.
u should see that it will work
-----Original Message-----
From: Alec [mailto:clapun@graduate.hku.hk]
Sent: 05 October 2003 15:38
To: Lab
Subject: back-to-back FR encapsulation
Hi group,
Are thery configuration samples that allow running FR encapsulation over
back-to-back serial cable. I tried to run in my Cisco 2500, but fails.
regards,
alec
interface Serial1
ip address 1.1.1.5 255.255.255.0
encapsulation frame-relay
frame-relay intf-type dce
end
R5#conf t
Enter configuration commands, one per line. End with CNTL/Z.
R5(config)#int s1
R5(config-if)#clock rate 64000
%Error: This command applies only to DCE interfaces
R5(config-if)#
***Get your CCIE and a FREE vacation: Shop.GroupStudy.com***
This archive was generated by hypermail 2.1.4 : Mon Nov 24 2003 - 07:52:57 GMT-3