From: asadovnikov (asadovnikov@comcast.net)
Date: Wed Sep 24 2003 - 02:02:51 GMT-3
Agree, this is a great router. To bad support stops at VERY early 12.2.T so
for long term study it may not be the best choice, but I have couple of 4700
in my lab and other then software version have no complains at all. Price
is right as well
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
christopher snow
Sent: Tuesday, September 23, 2003 9:39 PM
To: Larry Roberts
Cc: ccielab@groupstudy.com
Subject: Re: Inter-Vlan router config
The 4500-M and 4700 has a decent 12.2 feature set and
you can get those pretty cheap on ebay. Then buy a
NP-1FE for it. Router and card should go for around
$450 to $500 if you watch the auctions. The 2620 is
much better but it will cost ya :)
Chris Snow
--- Larry Roberts <larryr@netbeam.net> wrote:
> Rob,
>
> As of IOS 12.1(5)T, you can also do dot1q trunking
> on a 2610 with just a 10
> mbps interface, so the Fast Ethernet requirement no
> longer applies. I would
> however recommend getting a 2600 with a Fast
> Ethernet card like Rob
> suggested or a 2620 with a Fast Ethernet interface.
> This will allow you to
> practice both dot1q and ISL trunking. The bare
> minimum to practice InterVLAN
> routing with dot1q would be a 1721 or 2610.
>
> HTH,
> Larry Roberts
> CCIE #7886 (R&S / Security)
>
>
> ----- Original Message -----
> From: "Rob Laidlaw" <laidlaw@consecro.com>
> To: <cisco@tsgi.net>; <ccielab@groupstudy.com>
> Sent: Tuesday, September 23, 2003 4:00 PM
> Subject: Re: Inter-Vlan router config
>
>
> > You have two choices from the bottom of the cisco
> product line. A cisco
> > 1721 can do dot1q (not sure about isl)
> encapsulation so that will work for
> > you or any 2600 with 1 fast ethernet interface
> (you need at least 100mbps
> > interface to do dot1q or isl so the 2500 series is
> out). Good luck
> >
> > -Rob
> >
> > ----- Original Message -----
> > From: <cisco@tsgi.net>
> > To: <ccielab@groupstudy.com>
> > Sent: Tuesday, September 23, 2003 6:02 PM
> > Subject: Inter-Vlan router config
> >
> >
> > > Hi,
> > >
> > > What is the lowest price router that should be
> obtained to implement
> > Inter-VLAN configuration for
> > > CCIE lab.
> > > What model router should be purchased for home
> lab?
> > > Please advise.
> > >
> > > Darly Coupet
> > >
> > > ***Get your CCIE and a FREE vacation:
> Shop.GroupStudy.com***
> > >
>
This archive was generated by hypermail 2.1.4 : Wed Oct 01 2003 - 07:24:34 GMT-3