From: navaid@rogers.com
Date: Thu Sep 18 2003 - 13:29:44 GMT-3
As you can see in following config. I have vlan 2 configured as access vlan. I also have native vlan set to 20. This is conflicting because my understanding was that we can set native vlan using two methods.
1) using switchport access vlan command
2) using switchport trunk native vlan command.
Since port is not forced to trunk ( I don't have "switchport mode trunk" command) can we say that vlan 2 is used if it is a non trunking port and vlan 20 is used as native vlan if it is truning port ?
interface FastEthernet0/2
switchport access vlan 2
switchport trunk encapsulation dot1q
switchport trunk native vlan 20
switchport mode access
switchport voice vlan 20
no ip address
spanning-tree portfast
end
Navaid
1
***Get your CCIE and a FREE vacation: Shop.GroupStudy.com***
This archive was generated by hypermail 2.1.4 : Wed Oct 01 2003 - 07:24:30 GMT-3