From: Paul Chen (cpjchen@starhub.net.sg)
Date: Wed Sep 17 2003 - 13:49:35 GMT-3
Brian,
Thanks, I got it to work. I just got confused looking at the Netmaster's lab
solutions.
By the way, I can't figure this out ?
If I have a dial peer with destination-pattern 4085551234
If I use a destination pattern of 408555.+ it will not connect to the dial
peer. But if I have 4085556 then it would work .
CCO documentation states that .+ implies a single digit occurred ONE or
MORE times, so 4085551234 should work ? One digit works but what about more
times ?
Same goes for .% and + and % and ? symbols - they don't work with the above
dial-peer
Go to TABLE 12 at this URL - perhaps I don't really understand the concepts
http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_configuratio
n_guide_chapter09186a0080080aec.html
Thanks,
Paul
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Brian Sims
Sent: Wednesday, September 17, 2003 11:23 PM
To: ccielab@groupstudy.com
Subject: RE: Destination-pattern- Calling all VOIP Experts
Hey Paul,
Adding this voip dial-peer will work fine. I have used it on a client's
voice network.
dial-peer voice 100 voip
destination-pattern 55574.....
session target ipv4:135.15.13.1
Brian
dial-peer voice 100 voip
destination-pattern 55574.....
session target ipv4:135.15.13.1
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Todor Georgiev
Sent: Wednesday, September 17, 2003 6:06 AM
To: Paul Chen; ccielab@groupstudy.com
Subject: RE: Destination-pattern- Calling all VOIP Experts
Hi,
Try this
dial-peer voice 100 voip
destination-pattern 55574T
session target ipv4:135.15.13.1
or
dial-peer voice 100 voip
destination-pattern 55574.....
session target ipv4:135.15.13.1
-----Original Message-----
From: Paul Chen [mailto:cpjchen@starhub.net.sg]
Sent: Wednesday, September 17, 2003 12:34 PM
To: ccielab@groupstudy.com
Subject: Destination-pattern- Calling all VOIP Experts
Hi Everyone,
Can anyone figure out how to do this ? Any help appreciated.
R1
dial-peer voice 100 pots
destination-pattern 5557412345
port 1/0/0
!
dial-peer voice 101 pots
destination-pattern 5557434567
port 1/0/1
!
dial-peer voice 300 voip
destination-pattern 7038103333
session target ipv4:135.15.13.3
-Question ------------R3- call any R1's phones with only one voip
dial-peer.
dial-peer voice 300 pots
destination-pattern 7038103333
port 1/0/0
!
dial-peer voice 100 voip
destination-pattern 55574[(12345),(34567)]$ ----------- This Does
NOT
work ? I tested it. Busy tone after dialing 55574
session target ipv4:135.15.13.1
***Get your CCIE and a FREE vacation: Shop.GroupStudy.com***
This archive was generated by hypermail 2.1.4 : Wed Oct 01 2003 - 07:24:29 GMT-3