From: Daniel Sheedy (dansheedy@gmx.net)
Date: Fri Sep 12 2003 - 08:02:12 GMT-3
Hi dt,
I found an interesting link here:
http://www.cisco.com/en/US/tech/tk389/tk689/technologies_tech_note09186a0080094663.shtml
It uses IRB to span a VLAN over a router, and seems to be fairly well
explained. I looks like the similar setup to what you are trying to
achieve.
It even gives the config which is handy. Not too many commands are needed,
and nothing to tricky.
Daniel Sheedy
----- Original Message -----
From: "ccie2be" <ccie2be@nyc.rr.com>
To: "Group Study" <ccielab@groupstudy.com>
Sent: Thursday, September 11, 2003 10:59 PM
Subject: VTP and bridged interfaces on routers
> Hi all,
>
> I'm unable to test this so I'm posting this question.
>
> Assume the following:
>
> Switch1---trunk------fa0/0 router fa0/1----trunk----Switch2
>
> On the router the 2 fa interfaces are bridged together.
>
> Switch1 is a vtp server and Switch2 is a vtp client.
>
> Question? Will vtp messages get from Switch 1 to Switch 2 without any
> special configuration on the router other than bridging the 2 fastethernet
> interfaces together?
>
> If some configuration is needed on the router to make this work, what
needs to
> be done?
>
> Thanks in advance, dt
>
>
> _______________________________________________________________________
> You are subscribed to the GroupStudy.com CCIE R&S Discussion Group.
>
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Wed Oct 01 2003 - 07:24:26 GMT-3