From: Brian McGahan (bmcgahan@internetworkexpert.com)
Date: Wed Sep 03 2003 - 15:20:54 GMT-3
Alec,
It will only match a single character then. As soon as the
single character is input, the router will do call setup. This will not
be true for the 'csim start' command though, since the string is sent
all at once. From an actual phone though, the string is sent 1
character at a time.
HTH
Brian McGahan, CCIE #8593
bmcgahan@internetworkexpert.com
Internetwork Expert, Inc.
http://www.InternetworkExpert.com
Toll Free: 877-334-8987
Direct: 708-362-1418 (Outside the US and Canada)
-----Original Message-----
From: Alec [mailto:clapun@graduate.hku.hk]
Sent: Wednesday, September 03, 2003 10:24 AM
To: Brian McGahan; 'Paul Chen'; ccielab@groupstudy.com
Subject: Re: Destination pattern symbols
So what if I use destination-pattern . for voice default route ? What's
the
difference with .T ?
----- Original Message -----
From: "Brian McGahan" <bmcgahan@internetworkexpert.com>
To: "'Paul Chen'" <cpjchen@starhub.net.sg>; <ccielab@groupstudy.com>
Sent: Wednesday, September 03, 2003 4:22 PM
Subject: RE: Destination pattern symbols
> Paul,
>
> T actually means interdigit timeout. The default interdigit
> timeout is 10 seconds. Each time you dial a digit, the router is
going
> to wait 10 seconds before doing call setup. After 10 seconds have
> expired, the router assumes that what you have entered so far is the
> complete dial string, and does call setup on those digits. You can
> modify the interdigit timeout with the voice-port command 'timeouts
> inter-digit'.
>
> The combination of the . (any single character) and the T (wait
> for additional characters) effectively defines a default route for
> voice.
>
>
> HTH,
>
> Brian McGahan, CCIE #8593
> bmcgahan@internetworkexpert.com
>
> Internetwork Expert, Inc.
> http://www.InternetworkExpert.com
> Toll Free: 877-334-8987
> Direct: 708-362-1418 (Outside the US and Canada)
>
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf
Of
> Paul Chen
> Sent: Wednesday, September 03, 2003 3:05 AM
> To: ccielab@groupstudy.com
> Subject: Destination pattern symbols
>
> Hi,
>
>
>
> Could someone please explain to me what these symbols mean:
>
>
>
> Destination-pattern .T
>
>
>
> A dot implies a single character right ?
>
>
>
> The T symbol implies a variable length dial string.
>
>
>
> Does the combination of the 2 symbols mean dial any number ?
>
>
>
> Thanks.
>
> Paul
>
>
>
This archive was generated by hypermail 2.1.4 : Wed Oct 01 2003 - 07:24:22 GMT-3