From: Mike Williams (ccie2be@swbell.net)
Date: Thu Aug 28 2003 - 20:21:59 GMT-3
Uh.... He used the command as his example. You can question mark your
way through to see the exact syntax like so (note the spaces between the
numbers, the comma and the dash when specifying multiple vlans):
ROUTER(config)#monitor session 1 ?
destination SPAN destination interface or VLAN
filter SPAN filter VLAN
source SPAN source interface, VLAN
ROUTER(config)#monitor session 1 source ?
interface SPAN source interface
remote SPAN source Remote
vlan SPAN source VLAN
ROUTER(config)#monitor session 1 source vlan ?
<1-4094> SPAN source VLAN
ROUTER(config)#monitor session 1 source vlan 1 ?
, Specify another range of VLANs
- Specify a range of VLANs
both Monitor received and transmitted traffic
rx Monitor received traffic only
tx Monitor transmitted traffic only
<cr>
ROUTER(config)#monitor session 1 source vlan 1 , ?
<1-4094> SPAN source VLAN
ROUTER(config)#monitor session 1 source vlan 1 , 210 ?
, Specify another range of VLANs
- Specify a range of VLANs
both Monitor received and transmitted traffic
rx Monitor received traffic only
tx Monitor transmitted traffic only
<cr>
ROUTER(config)#monitor session 1 source vlan 1 , 210 - ?
<1-4094> SPAN source VLAN
ROUTER(config)#monitor session 1 source vlan 1 , 210 - 1000 ?
, Specify another range of VLANs
both Monitor received and transmitted traffic
rx Monitor received traffic only
tx Monitor transmitted traffic only
<cr>
ROUTER(config)#monitor session 1 source vlan 1 , 210 - 1000 rx ?
<cr>
HTH,
Mike W.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Jim Phillipo
Sent: Thursday, August 28, 2003 5:16 PM
To: 'MADMAN'
Cc: ccielab@groupstudy.com
Subject: RE: 6500 SPAN Sessions
Do u know the syntax ?
-----Original Message-----
From: MADMAN [mailto:dmadlan@qwest.com]
Sent: Thursday, August 28, 2003 4:59 PM
To: Jim Phillipo
Cc: ccielab@groupstudy.com
Subject: Re: 6500 SPAN Sessions
Yes:
Native6506(config)#monitor session 1 source vlan 1 - 10 both ?
<cr>
Dave
Jim Phillipo wrote:
>Is it possible to have one port SPAN multiple VLANS using native CAT OS
>?
>
>
>TIA
>
>Jim Phillipo, CCNP, CCDP
>Sr. Internetworking Engineer
>W: 401.456.1821 F: 401.456.0599 M: 508.982.8923
>90 Royal Little Drive, Providence, RI 02904
>www.guardent.com
>_____________________________________________________
>G U A R D E N T
>Security | Privacy | Data Protection
>
>
>_______________________________________________________________________
>You are subscribed to the GroupStudy.com CCIE R&S Discussion Group.
>
>Subscription information may be found at:
>http://www.groupstudy.com/list/CCIELab.html
>
>
>
-- David Madland CCIE# 2016 Sr. Network Engineer Qwest Communications 612-664-3367"Emotion should reflect reason not guide it"
This archive was generated by hypermail 2.1.4 : Tue Sep 02 2003 - 18:54:09 GMT-3