From: jfaure@sztele.com
Date: Wed Aug 27 2003 - 14:00:40 GMT-3
Hi Folks:
I'm reviewing the dlsw+ issues and, however i'm using the docs in the cd
doc, i have this doubt (i hope somebody can clarify it):
What is the difference between dlsw peer-on-demand-defaults" and the use of
the "dynamic" keyword when you define the remote peer?
I though that if you need to define SNA on demand, you must specify
"keepalive 0" in your peer definition. Then, i've seen you also have the
command "dlsw peer-on-demand-defaults" . At first i though this second
command was to just adjust some issues for an on demand dlsw config, but it
see this command also have the keyword "keepalive" and it is equal to 30
secs by default.
Anyone can clarify what is the purpose of each command and when do you need
to use them?
Regards
Juan Faure Ferrer
email: jfaure@sztele.com
Lmnea de Negocio de Telematica y CC
Ingeniero de Integracisn de Redes y Sistemas
----------------------------------------------------------------------------
SOLUZIONA TELECOMUNICACIONES
Servicios Profesionales de UNION FENOSA
Jerez, 3
28016 MADRID
tel 91 579 30 00 fax 91 350 72 83
---------------------------------------------------------------------------
This archive was generated by hypermail 2.1.4 : Tue Sep 02 2003 - 18:54:07 GMT-3