From: MMoniz (ccie2002@tampabay.rr.com)
Date: Sun Aug 17 2003 - 15:40:07 GMT-3
It is possibly because this PVC was created before and the router has no
been reloaded or power cycled
or in fact you have this PVC assigned to S0/0
Whenever you create a PVC or subinterface it does not go away until reload.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Rajagopal S
Sent: Sunday, August 17, 2003 1:43 PM
To: ccielab@groupstudy.com
Subject: frame-relay map
Hi all,
I'm configuring a point to multipoint FR network. All necessary
configurations on the FR switch has been done.
When I configure FR map command on the edge router, I get the following
error:
R1(config)#int ser 0/0.1 multipoint
R1(config-subif)#frame-relay map ip 10.10.1.5 105
%PVC already assigned to interface Serial0/0
The configs on S0/0 is as follows :
interface Serial0/0.1 multipoint
ip address 10.10.1.1 255.255.0.0
frame-relay map ip 10.10.1.2 102
end
Any idea asto what the problem might be ?
Cheers
Raj
---------------------------------
Do you Yahoo!?
Yahoo! SiteBuilder - Free, easy-to-use web site design software
This archive was generated by hypermail 2.1.4 : Tue Sep 02 2003 - 18:54:00 GMT-3