From: Peng Zheng (zpnist@yahoo.com)
Date: Sun Aug 17 2003 - 13:47:31 GMT-3
What's default bandwidth value for bri interface? 64
or 128 ? Or every time I was asked for dialer load
config, I should config bandwidth under interface?
Thanks for help.
--- Anant Chakole <anantmc@rediffmail.com> wrote:
> Hi Peng
>
> It is the % load of the Interface and not the
> individual channel. When
> the load on the interface reaches the 50% of the
> bandwidth then it
> should dial the second channel automatically. As it
> works on the scale
> of 0 to 255, 127 will not satisfy the condition as
> 50% of 255 is 127.5,
> so use the threshold value as 128. And by default it
> applies on the
> outbound interface if you have not mentioned
> anything. So it is best
> practice to use either statement at the end of the
> command.
>
> Regards
> Anant
>
> Peng Zheng wrote:
>
> >Is that the percentage of one channel or the
> >percentage of two channel?
> >
> >For example:
> >
> >Ask to bring up second link when bandwidth up to
> 50%
> >of one first channel.
> >
> >SHould I use:
> >
> >dialer load 63 either or
> >dialer load 127 either
> >
> >Thanks.
> >
> >
> >__________________________________
> >Do you Yahoo!?
> >Yahoo! SiteBuilder - Free, easy-to-use web site
> design software
> >http://sitebuilder.yahoo.com
> >
> >
>
>_______________________________________________________________________
> >You are subscribed to the GroupStudy.com CCIE R&S
> Discussion Group.
> >
> >Subscription information may be found at:
> >http://www.groupstudy.com/list/CCIELab.html
>
>
>
This archive was generated by hypermail 2.1.4 : Tue Sep 02 2003 - 18:54:00 GMT-3