From: Chen Kwong Wai William (kwchen@netvigator.com)
Date: Wed Aug 13 2003 - 10:36:56 GMT-3
Dear all,
Anyone try to use the "csim start" command to test the Voice over IP
test on remote rack?
The following command shows a successful call or not? I have test the
connectivity between R4 and R7.
R7#csim start 4411
csim: called number = 4411, loop count = 1 ping count = 0
csim err csimDisconnected recvd DISC cid(38)
csim: loop = 1, failed = 1
csim: call attempted = 1, setup failed = 1, tone failed = 0
R7#sh run | begin dial-peer
dial-peer cor custom
!
!
!
dial-peer voice 10 pots
destination-pattern 7711
port 1/0/0
!
dial-peer voice 20 voip
destination-pattern 4411
session target ipv4:110.99.4.4
codec g723r63
!
dial-peer voice 1 pots
destination-pattern 7000
port 1/0/0
!
dial-peer voice 2 pots
preference 1
destination-pattern 7000
port 1/0/1
!
R4#sh run | begin dial-peer
dial-peer cor custom
!
!
!
dial-peer voice 10 pots
destination-pattern 4411
port 1/0/0
!
dial-peer voice 20 voip
destination-pattern 7711
session target ipv4:110.99.7.7
codec g723r63
!
Best Regards,
William Chen
This archive was generated by hypermail 2.1.4 : Tue Sep 02 2003 - 18:53:58 GMT-3