From: John Matijevic (matijevi@bellsouth.net)
Date: Sat Aug 02 2003 - 12:29:22 GMT-3
Hello Team,
I know there is an ealier thread on 7/7/03, on this that I read, but no
response.
I am trying to change the state from blocking to forwarding on a non-root
switch.
I used the command under interface:
spanning-tree vlan 1 port-priority 100,
By lowering the priority the port should go into forwarding state and the rest
should be blocking. However, this is not happening, I know there was an
earlier thread on this but there was no response.
p1s2#sh span vlan 1
VLAN0001
Spanning tree enabled protocol ieee
Root ID Priority 24577
Address 000b.be5d.5b80
Cost 19
Port 21 (FastEthernet0/21)
Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec
Bridge ID Priority 32769 (priority 32768 sys-id-ext 1)
Address 000b.46d9.2580
Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec
Aging Time 300
Interface Port ID Designated Port
ID
Name Prio.Nbr Cost Sts Cost Bridge ID
Prio.Nbr
---------------- -------- --------- --- --------- --------------------
--------
Fa0/21 128.21 19 FWD 0 24577 000b.be5d.5b80 128.21
Fa0/22 128.22 19 BLK 0 24577 000b.be5d.5b80 128.22
Fa0/23 128.23 19 BLK 0 24577 000b.be5d.5b80 128.23
Fa0/24 100.24 19 BLK 0 24577 000b.be5d.5b80 128.24
p1s2#
port fa0/21 is the port im trying to change, on the non-root switch.
Any suggestions?
Sincerely,
Matijevic
This archive was generated by hypermail 2.1.4 : Tue Sep 02 2003 - 18:53:51 GMT-3