From: Jason Cash (cash2001@swbell.net)
Date: Thu Jul 31 2003 - 19:24:14 GMT-3
I was doing a scenario today and it called for RIP b/w two neighbors in the
153.1.61.0 /28 networks. It instructed the 'Version 2' could not be used on
the route process. However, the solution had 'ip rip send version 2' in
it's serial interface. In looking up on the DOC CD, I found this:
version
To specify a Routing Information Protocol (RIP) version used globally by the
router, use the version command in router configuration mode. To restore the
default value, use the no form of this command.
version {1 | 2}
no version
Defaults
The software receives RIP Version 1 and Version 2 packets, but sends only
Version 1 packets.
My question is this: Is there any difference in have the interface send
Version 2 and the process running Rip 1 or running RIP version 2 alone which
by default sends version 1 and 2?
This archive was generated by hypermail 2.1.4 : Wed Aug 06 2003 - 06:53:00 GMT-3