From: Glenn Johnson (gjcomcast@comcast.net)
Date: Mon Jul 28 2003 - 05:33:53 GMT-3
If a solution exists, there is probably a better trick than CBWFQ
w/FRTS. I was just thinking about how you might indirectly identify
(through your class statement match access-group commands) the type of
traffic flowing over each VC via protocol type and/or source and/or
destination. If you are curious about cbwfq and frts -- please see
http://www.cisco.com/en/US/tech/tk713/tk237/technologies_configuration_examp
le09186a008009486b.shtml
I haven't tried this out yet but I'm curious to know if others have
done so.
If no traffic falls within defined or default classes, is it not
"shaped"? Or is it "shaped" using just the CIR, Bc, Be, etc., values?
Thanks
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of E03k
Sent: Monday, July 28, 2003 3:37 AM
To: gjcomcast@comcast.net; ccielab@groupstudy.com
Subject: 4d@e(Re): RE: How should i do..?
Thanks for your-reply..
-If you can configure FRTS with CBWFQ, is there any method to identify the
pvc between
R1 and R2?
-If you have to use a FRTS only, is there no method?
--- Original Message ---
:83=@L(From): "Glenn Johnson" gjcomcast@comcast.net
9^4B@L(To): wwwjjang@chol.com
:83=@O=C(Date): Mon, 28 Jul 2003 02:47:31 -0400
A&8q(Subject): RE: How should i do..?
Does it have to be FRTS or can it be CBWQ with FRTS?
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
wwwjjang@chol.com
Sent: Monday, July 28, 2003 2:06 AM
To: ccielab@groupstudy.com
Subject: How should i do..?
-----------
Assumtion>
-----------
-R1,R2 & R3 are connected with F/R
-R1 is HUB. R2 & R3 are Spokes
-R1,R2 & R3 are in a same subnet
-R1's FR-int is Multipoint & must use 'FR-map' command.
R2 & R3's FR-ints are a Physical-int.
-----------
My-Query>
-----------
If i configure a FRTS in R1's Multipoint-Subint,
The FR-class will affect to the 2 PVCs (R1-R2 ,R1-R3).
but I want to remove the FRTS-effects at the R1-R3's PVC.
So, The FRTS affects to the R1-R2's pvc only..
How should i do..?
This archive was generated by hypermail 2.1.4 : Wed Aug 06 2003 - 06:52:55 GMT-3