From: Deepesh Chouhan (deepesh@cisco.com)
Date: Wed Jul 23 2003 - 08:47:01 GMT-3
Hi
You can use
distance eigrp <inter> <exter> command. But this does not support selection
using ACL
thanks
deepesh
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
> CCIEStudy
> Sent: Wednesday, July 23, 2003 4:10 AM
> To: Snow, Tim; ccielab@groupstudy.com
> Subject: Re: eigrp distance for external routes
>
>
> Yes, there is no way the change the AD for EIGRP External route.
>
> Des
> ----- Original Message -----
> From: "Snow, Tim" <timothy.snow@eds.com>
> To: <ccielab@groupstudy.com>
> Sent: Wednesday, July 23, 2003 1:11 AM
> Subject: eigrp distance for external routes
>
>
> > I'd just like bounce this question off you so I know i'm not loosing my
> > mind.
> > The following command under eigrp will only affect internal eigrp routes
> > correct?
> >
> > distance 95 172.30.200.7 0.0.0.0 2
> >
> > IP Expert Lab #30 says "r5 should know these routes with an AD
> of 95" but
> I
> > think the only way I can do this is like this
> >
> > distance eigrp 90 95
> >
> > But that will affect all of them.
> >
> > Could anyone think of something i'm missing.
> >
> > Tim
> >
> >
> > _______________________________________________________________________
> > You are subscribed to the GroupStudy.com CCIE R&S Discussion Group.
> >
> > Subscription information may be found at:
> > http://www.groupstudy.com/list/CCIELab.html
>
>
> _______________________________________________________________________
> You are subscribed to the GroupStudy.com CCIE R&S Discussion Group.
>
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Wed Aug 06 2003 - 06:52:50 GMT-3