From: beda jain (bpjain@cisco.com)
Date: Tue Jul 22 2003 - 19:24:05 GMT-3
Hi,
when i run ip wcc ver 2, i did not see router identifier. but when i
configure ver 1 i saw it.
Is there any else we need to to make it work in ver 2.
ip wccp web
int e0/0
ip wccp web-cache redirect in
r6#sh ip wccp
Global WCCP information:
Router information:
Router Identifier: -not yet determined-
Protocol Version: 2.0
Service Identifier: web-cache
Number of Cache Engines: 0
Number of routers: 0
Total Packets Redirected: 0
Redirect access-list: -none-
Total Packets Denied Redirect: 0
Total Packets Unassigned: 0
Group access-list: -none-
Total Messages Denied to Group: 0
Total Authentication failures: 0
but ver 1 it works.
r6#sh
*Jul 22 22:23:17.690: %SYS-5-CONFIG_I: Configured from console by consoleip
wccp
Global WCCP information:
Router information:
Router Identifier: 133.11.6.6
Protocol Version: 1.0
Service Identifier: web-cache
Number of Cache Engines: 0
Number of routers: 1
Total Packets Redirected: 0
Redirect access-list: -none-
Total Packets Denied Redirect: 0
Total Packets Unassigned: 0
Group access-list: -none-
Total Messages Denied to Group: 0
Total Authentication failures: 0
This archive was generated by hypermail 2.1.4 : Wed Aug 06 2003 - 06:52:49 GMT-3