From: rionaldi (rionaldi@cbn.net.id)
Date: Sun Jul 13 2003 - 10:26:08 GMT-3
Before someone send me warnings regarding word "On the lab" that break NDA
in
my question.. I would like to apologize for bad wording.. "On the lab" means
my home lab and that was the requirement.
----- Original Message -----
From: "rionaldi" <rionaldi@cbn.net.id>
To: "CCIE Study Group" <ccielab@groupstudy.com>
Sent: Sunday, July 13, 2003 9:22 AM
Subject: Questions
> 1. If we being asked for full connectivity at the en of the lab.... does
it
> means that I must be able to ping all interfaces and routes.. event it
from
> the backbone.. (of course diregard route being filtered).
>
>
> 2. I tried to testing the Voip configuration using csim start,, which
response
> shows the correct one.. and what these message means
>
> csim: called number = 4444, loop count = 1 ping count = 0
>
> csim: loop = 1, failed = 1
> csim: call attempted = 1, setup failed = 1, tone failed = 0
>
> ----------------
> r4#csim start 7777
> csim: called number = 7777, loop count = 1 ping count = 0
>
> csim err csimDisconnected recvd DISC cid(4)
> csim err:csimStateError: cid(4), st(2), oldst(2), ev(7)
> csim: loop = 1, failed = 1
> csim: call attempted = 1, setup failed = 1, tone failed = 0
>
> 3. Just checking... when we redistributing OSPF/EIGRP (with different
subnet
> mask with the same major network) into RIP v1 area.. is there any other
way to
> do it other than using:
> 1. Tunneling
> 2. Secondary Ip address.
> 3. Summarization at the OSPF/EIGRP to match subnet mask of the RIP area ?
>
>
> regards,
> rionaldi
>
>
> _______________________________________________________________________
> You are subscribed to the GroupStudy.com CCIE R&S Discussion Group.
>
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Wed Aug 06 2003 - 06:52:38 GMT-3