Anycast RP

From: SHARMA,MOHIT (HP-Germany,ex1) (mohit.sharma@hp.com)
Date: Sun Jul 13 2003 - 09:53:09 GMT-3

• Next message: Ebon Knight: "RE: Telnet at high port"
• Previous message: SHARMA,MOHIT (HP-Germany,ex1): "RE: Creepy 3550"
• Next in thread: P729: "Re: Anycast RP"
• Maybe reply: P729: "Re: Anycast RP"
• Maybe reply: Ken.Farrington@barclayscapital.com: "RE: Anycast RP"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hi All,

Has anyone checked this config on the CD for anycast rp
http://www.cisco.com/univercd/cc/td/doc/cisintwk/intsolns/mcst_sol/rps.htm#x
tocid12

In the config for anycast RP with Auto-RP scenario, they are using Lo0 for
router 75a to source the rp-announce.
ip pim send-rp-announce Loopback0 scope 32 group-list 10

ip pim send-rp-discovery Loopback0 scope 32

The question is, should'nt they use Lo 1 here?? As that is the interface
with the commomon IP for both the routers.
I guess that was the whole point of the excercise to make them redundant.

Any Multicast Guru, kindly Comment.

Thanks,

Mohit.

• Next message: Ebon Knight: "RE: Telnet at high port"
• Previous message: SHARMA,MOHIT (HP-Germany,ex1): "RE: Creepy 3550"
• Next in thread: P729: "Re: Anycast RP"
• Maybe reply: P729: "Re: Anycast RP"
• Maybe reply: Ken.Farrington@barclayscapital.com: "RE: Anycast RP"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Wed Aug 06 2003 - 06:52:38 GMT-3