From: rionaldi (rionaldi@cbn.net.id)
Date: Sat Jul 12 2003 - 23:23:42 GMT-3
one more question how to make when the telnet/ console connection being used..
it is coming direct to previlage mode...
----- Original Message -----
From: rionaldi
To: CCIE Study Group
Sent: Sunday, July 13, 2003 9:22 AM
Subject: Questions
1. If we being asked for full connectivity at the en of the lab.... does it
means that I must be able to ping all interfaces and routes.. event it from
the backbone.. (of course diregard route being filtered).
2. I tried to testing the Voip configuration using csim start,, which
response shows the correct one.. and what these message means
csim: called number = 4444, loop count = 1 ping count = 0
csim: loop = 1, failed = 1
csim: call attempted = 1, setup failed = 1, tone failed = 0
----------------
r4#csim start 7777
csim: called number = 7777, loop count = 1 ping count = 0
csim err csimDisconnected recvd DISC cid(4)
csim err:csimStateError: cid(4), st(2), oldst(2), ev(7)
csim: loop = 1, failed = 1
csim: call attempted = 1, setup failed = 1, tone failed = 0
3. Just checking... when we redistributing OSPF/EIGRP (with different
subnet mask with the same major network) into RIP v1 area.. is there any other
way to do it other than using:
1. Tunneling
2. Secondary Ip address.
3. Summarization at the OSPF/EIGRP to match subnet mask of the RIP area ?
regards,
rionaldi
This archive was generated by hypermail 2.1.4 : Wed Aug 06 2003 - 06:52:38 GMT-3