From: badger (badger@pongo.org)
Date: Thu Jun 26 2003 - 00:38:26 GMT-3
Hello ccielab,
I'm still struggling with a basic issue of how to apply the service
policy to a frame interface. I have two scenarios that are still
puzzling and welcome anyone to offer up a solution/explanation.
The first scenario is on a FR physical interface and the basic two
questions here are (1) do you need to turn on "traffic shaping" for the
service policy to work (2) are you required to use the "frame-relay
map-class xxx
service-policy yyy"
Or, does the service policy get applied directly to the interface
such as "service-policy output yyy"
As a side note...it may be my code, 12.1(14)T, but whenever I use the
"frame-relay map-class xxx" method, my routers instantly reload!
The second scenario is on a FR interface with two point-to-point sub
interfaces. Say I want to the same service-policy to be applied to
both the sub interfaces, redundant links, then the question(s) are
(1) Again, does FR traffic shaping need to be enabled? (2) does the
service policy get applied to the physical interface, or to both sub
interfaces? (3) Whatever the answer is to (2), do I use the
"frame-relay map class" method, or apply the "service-policy output
yyy" directly to physical/sub-interface?
I have read many docs, books, and examples and seen this accomplished
in so many ways that my head is still spinning, but I would really
like to get this nailed down.
Thanks and
-- Best regards, badger mailto:badger@pongo.org
This archive was generated by hypermail 2.1.4 : Fri Jul 04 2003 - 11:11:10 GMT-3