From: Jonathan V Hays (jhays@jtan.com)
Date: Mon Jun 23 2003 - 15:14:39 GMT-3
You might use the formulas from this document:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/
fqos_c/fqcprt4/qcfpolsh.htm#1000977
---- We recommend the following values for the normal and extended burst parameters:normal burst = configured rate * (1 byte)/(8 bits) * 1.5 seconds extended burst = 2 * normal burst ----
HTH
> -----Original Message----- > From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On > Behalf Of SHARMA,MOHIT (HP-Germany,ex1) > Sent: Monday, June 23, 2003 1:55 PM > To: ccielab@groupstudy.com > Subject: CAR calculations > > > Hi All, > > Need some help with CAR, > > If in the question it specifies that the specified traffic > should not exceed > 1 MBPS. > > What would be the vlaues of the normal burst and the excess burst- > I found this on Cisco, but doesnt help much. > > ""Recommended Burst Values > Cisco recommends the following values for the normal and > extended burst > parameters: > > normal burst = configured rate * (1 byte)/(8 bits) * 1.5 seconds > extended burst = 2 * normal burst "" > > Could somebody please explain taking just 1mbps as a reffernce value. > > Thanks, > Mohit. > > > ______________________________________________________________ > _________ > You are subscribed to the GroupStudy.com CCIE R&S Discussion Group. > > Subscription information may be found at: > http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Fri Jul 04 2003 - 11:11:07 GMT-3