From: Brian Dennis (brian@labforge.com)
Date: Tue Jun 03 2003 - 13:04:55 GMT-3
Are you sure the only option is 9600 for the aux port? The 2500s support
up to 38400. The newer routers support up to 115200.
GW2514(config-line)#line 1
GW2514(config-line)#rxspeed 38400
GW2514(config-line)#txspeed 38400
GW2514 (config-line)#^Z
GW2514#sho line 1
Tty Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns
Int
1 AUX 38400/38400 - - - - - 4 33 0/0
-
<snip>
GW2514#
You could have also just done "speed 38400" to set both rx/tx at the
same time.
Brian Dennis, CCIE #2210 (R&S/ISP-Dial/Security)
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
rionaldi
Sent: Tuesday, June 03, 2003 3:08 AM
To: CCIE Study Group
Subject: Aux Back-to-back Speed
Dear All,
Anyone know how to change the speed of back-to-back aux connection other
than
9.6 kbps in Cisco 2500 Router?
I used rxspeed and txspeed commands already but the option is ony
9600.
Regards,
Prio
This archive was generated by hypermail 2.1.4 : Fri Jul 04 2003 - 11:10:52 GMT-3