From: Alexander Arsenyev (ETL) (Alexander.Arsenyev@etl.ericsson.se)
Date: Mon May 26 2003 - 04:36:12 GMT-3
Hello,
1) set config-register to 0x2101
2) do not save config, reload the box
3) when it comes up, go into config mode and issue command "partition flash 1". You existing partitions will be merged and existing IOS preserved. It this step You can upgrade IOS, if desired. Save config.
4) set config-register to 0x2102, reload the box.
Cheers
Alex
-----Original Message-----
From: Tony Schaffran [mailto:tschaffran@cconlinelabs.com]
Sent: 26 May 2003 00:01
To: 'Emad'; 'CCIE LAB (E-mail)'
Subject: RE: flash partitions
Emad,
You will need to boot the router into boot mode. i.e. config reg 0x2101
You will then need to erase the flash. After the flash has been erased, you
should be able to issue the "no partition flash" command in config mode.
After that has been done, you can now load the desired IOS version. After
the IOS has been copied, don't forget to set the config reg back to 0x2102.
I hope this helps.
Tony Schaffran
Network Analyst
CCIE #11071
CCNP, CCNA, CCDA,
NNCDS, NNCSS, CNE, MCSE
www.cconlinelabs.com
Your #1 choice for online Cisco rack rentals.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of Emad
Sent: Sunday, May 25, 2003 11:25 AM
To: CCIE LAB (E-mail)
Subject: flash partitions
Folks,
I have two partitions of flash (each is 8 M) and I want to combine them
together to be seen as one modul 16 M flash , how can I do that?
sh ver
Cisco Internetwork Operating System Software
IOS (tm) 3000 Bootstrap Software (IGS-RXBOOT), Version 10.2(8a), RELEASE
SOFTWARE (fc1)
Copyright (c) 1986-1995 by cisco Systems, Inc.
Compiled Tue 24-Oct-95 15:46 by mkamson
Image text-base: 0x01020000, data-base: 0x00001000
ROM: System Bootstrap, Version 5.2(8a), RELEASE SOFTWARE
R9 uptime is 25 minutes
System restarted by reload
Running default software
cisco 2500 (68030) processor (revision D) with 8188K/2048K bytes of memory.
Processor board serial number 01534702 with hardware revision 00000000
X.25 software, Version 2.0, NET2, BFE and GOSIP compliant.
1 Ethernet/IEEE 802.3 interface.
2 Serial network interfaces.
32K bytes of non-volatile configuration memory.
8192K bytes of processor board System flash partition 1 (Read/Write)
8192K bytes of processor board System flash partition 2 (Read/Write)
Configuration register is 0x2101
thanx
This archive was generated by hypermail 2.1.4 : Mon Jun 02 2003 - 15:13:48 GMT-3