From: Jung, Jin (jin.jung@lmco.com)
Date: Fri May 23 2003 - 15:37:30 GMT-3
I normally setup virtual-link between two BRI routers.
This should fix it.
Jin jung...
-----Original Message-----
From: Tom Young [mailto:gitsyoung@yahoo.co.jp]
Sent: Friday, May 23, 2003 11:43 AM
To: ccielab@groupstudy.com
Subject: ospf 's routing
hi, group
The three routers, A--B--C are running ospf , A,B was linked by bri ,
belong area 1. B and C was line by serial port area 0.
If I add command ip ospf demand-circuit on B's bri
port, The C would not see the route to A or B's bri. If I cancel the
demand-circult command, the C could see the IA route to A, B's bri port,
Does is mornal? Or, May I have a way so that the C could see the bri's
address while use the demand-circuit on B's bri port?
Thanks alot
This archive was generated by hypermail 2.1.4 : Mon Jun 02 2003 - 15:13:47 GMT-3