From: Donny MATEO (donny.mateo@sg.ca-indosuez.com)
Date: Wed May 21 2003 - 23:29:46 GMT-3
Because when you're priority is 0, you can't become a DR.
so what you need is put the priority zero at the spoke and put the neighbor command at the hub router only.
Regards,
Donny
Danny.Andaluz@tri
aton-na.com To: ccielab@groupstudy.com
Sent by: cc:
nobody@groupstudy Subject: OSPF question
.com
05/22/2003 08:51
AM
Please respond to
Danny.Andaluz
Hello, Group. I've been trying to find an explanation to the following on
CCO but cannot find one. Not even the OSFP design guide has it.
I have a hub and spoke frame topology. The hub has a multipoint sub
interface and the spokes are physical. The requirement is to not use IP
OSPF network commands on the interface and to make sure the hub becomes the
DR. Upon configuring a priority of 0 on the spokes, I could not configure
neighbor statements under OSPF, which would satisfy the requirement of not
using the ip ospf network command. it would take the neighbor statement,
but it would not show up in the running config. Does anyone know why a
priority of 0 does not let the neighbor statement take?
Thanks,
Danny
This message is for information purposes only and its content
should not be construed as an offer, or solicitation of an offer,
to buy or sell any banking or financial instruments or services
and no representation or warranty is given in respect of its
accuracy, completeness or fairness. The material is subject
to change without notice. You should take your own independent
tax, legal and other professional advice in respect of the content
of this message. This message may contain confidential or
legally privileged material and may not be copied, redistributed
or published (in whole or in part) without our prior written consent.
This email may have been intercepted, partially destroyed,
arrive late, incomplete or contain viruses and no liability is
accepted by any member of the Credit Agricole Indosuez group
as a result. If you are not the intended recipient of this message,
please immediately notify the sender and delete this message
from your computer.
This archive was generated by hypermail 2.1.4 : Mon Jun 02 2003 - 15:13:46 GMT-3