From: kasturi cisco (kasturi_cisco@hotmail.com)
Date: Tue May 06 2003 - 12:29:00 GMT-3
Tom,
U are right and my mistake (i should have checked before replying).For
ISIS there are only 2 types "multipoint and p2p" as u have written.
2, When I have to use clns? I confused ! When u are using the physical
interface for ISIS and configure it is multipoint then in addition to the
"frelay map ip" u also need the frelay map clns command (check archives
there are threads). U dont need this for p2p interface type.
3, And if I don't use clns in p2p network , I also don't >need config
isis for type-1 , right?
I did not get Q. CLNS is a diffrent protocol and with newer codes u dont
need this. U still nedd to configure ISIS on the interface and the
interface DLCI.
Hope its clear.If u check the archives there have been lot of threads on
this and FR issues.
Good Luck,[IMAGE]
Kasturi.
>From: Tom Young >To: kasturi cisco >CC: ccielab@groupstudy.com >Subject:
Re: isis interface config >Date: Tue, 6 May 2003 10:19:22 +0900 (JST) >
>Kasturi, thanks for your reply, > >With your replay ,I had some question
> >Thanks again > > > --- kasturi cisco )gL >bZ[WF > >
------------------------------------------------------------------------
> >
Hi,
>
Yes u need not use clns in interface or global mode. >Its not needed for
P2MP interface also.Only mapping to >clns if Frelay is used is needed.
Ur second Q i >think u meant u cant run type 2 as they are in same area
>right ? bcoz if they are in same area they can be either >L1 or L1/L2
type. They cant be type 2.
" >the type 1 >between them, they could only run type 2 >because of >they
are in the same area. right? "
> Hope that clears ur doubt.
>
Good Luck,[IMAGE]>src="http://graphics.hotmail.com/emthup.gif" >width=12>
Kasturi.
> > > > >From: Tom Young > >Reply-To: Tom Young > >To:
ccielab@groupstudy.com > >Subject: isis interface config > >Date: Sun, 4
May 2003 23:21:48 +0900 (JST) > > > >Hi, group > > > > I read a file in
cisco homepage for isis >config as > >below. > > >
>http://www.cisco.com/warp/public/97/isis-frint.html > > > > >I have to
question, > > > >1, In the config of router H, F, if I set >isis in a >
>point-to-point interface, I think don't >need to use clns > >setting.
Not need the clns router isis in >interface and > >clns routing in globe
config mode. > >2, H, F are in a one network of isis, It >couldn't config
> > > > >Thanks alot > > >
>__________________________________________________ > > >Do You Yahoo!? >
>Yahoo! BB is Broadband by Yahoo! >http://bb.yahoo.co.jp/ >
------------------------------------------------------------------------
Win a PC. Every 15 >days! Just take >this quiz.> >
>__________________________________________________ >Do You Yahoo!?
>Yahoo! BB is Broadband by Yahoo! http://bb.yahoo.co.jp/ >
------------------------------------------------------------------------
What is SARS? Find out! Be informed.
This archive was generated by hypermail 2.1.4 : Mon Jun 02 2003 - 15:13:38 GMT-3
