From: Matt Nabors (mnabors@bcbsal.org)
Date: Fri May 02 2003 - 17:54:01 GMT-3
We were going to implement at one time. We haven't yet, but maybe soon. If
you get it working, I would be interested in how you did so.
Here is the link I used a lot:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122newft/122
t/122t8/ft_pod1.htm#43429
Good luck :)
Matt Nabors
Network Engineer
Blue Cross and Blue Shield of Alabama
----- Original Message -----
From: "Franck ccie" <cciefrank@hotmail.com>
To: <ccielab@groupstudy.com>
Sent: Friday, May 02, 2003 2:38 PM
Subject: Radius Packet of disconnect
> Any experience how to setup Radius PoD ( packet of disconnect) .I know
> how the configure PoD on the NAS 5300, but is there some thing
> to configure on the Radius server ... Thanks for your help. Frank.
>
> ------------------------------------------------------------------------
>
> MSN Messenger : discutez en direct avec vos amis ! Cliquez-ici
>
==============================================================================
CONFIDENTIALITY NOTICE
This e-mail is intended for the sole use of the individual(s) to whom it is
addressed, and may contain information that is privileged, confidential and
exempt from disclosure under applicable law. You are hereby notified that any
dissemination, duplication, or distribution of this transmission by someone
other than the intended addressee or its designated agent is strictly
prohibited. If you receive this e-mail in error, please notify me immediately
by replying to this e-mail.
==============================================================================
This archive was generated by hypermail 2.1.4 : Mon Jun 02 2003 - 15:13:36 GMT-3