From: ccie2be (ccie2be@nyc.rr.com)
Date: Tue Apr 29 2003 - 18:10:10 GMT-3
Hi,
Since Cisco introduced output modifiers, I find that I use them quite a bit,
for ex:
sh run | begin router
However, I haven't figured out a way to limit the number of lines returned.
For example, in the output of the above command, it gives me everthing from
"router ... to the end of the config file when typically, what I really want
is just to see the section that starts with "router ... ". In other words,
just what's configured under the routing process be it OSPF or Eigrp or BGP.
If there's a way to do that, could somebody tell me. I'd really appreciate
it. Thanks, Jim
This archive was generated by hypermail 2.1.4 : Thu May 01 2003 - 13:36:09 GMT-3