From: Eric Fisher (efisher@optonline.net)
Date: Fri Apr 25 2003 - 15:10:30 GMT-3
Do you need to enable clns routing to get ISIS to work. I have seen two types of configs and this is getting me a little confused.
clns routing
interface ser 1
encap frame
interface ser 1.1 point-to-point
ip address 10.20.20.2 255.255.255.0
ip router isis
clns router isis <---is this needed.
frame-relay interface-dlci 103
router isis
net 49.0001.2222.2222.2222.00
is-type level-2
the above came from cisco
this config below came from a ccie class
interface ser 1
encap fram
ip add 10.20.20.2 255.255.255.0
ip router isis
fram map ip 10.20.20.1 103 broad
fram map clns 10.20.20.1 103 broad
router isis
network 49.0001.2222.2222.2222.00
is type level-2
what does the clns router isis command do, . and do you need to enable clns routing because the answer sheet I have from the class clns routing is not in there but the map statements are.
Thanks
Eric
This archive was generated by hypermail 2.1.4 : Thu May 01 2003 - 13:36:07 GMT-3