From: Colburn, Jeffrey, PENREN\\SMS (colburnj@army.pentagon.mil)
Date: Thu Apr 24 2003 - 08:50:59 GMT-3
I looked in the archive and did not see anything closely relating to what I
am experiencing.
In the midst of configuring my lab, a router that I am not currently working
on will hang. I still receive log messages, but the console prompt
disappears. I would normally relate this to high CPU utilization, but I
only had frame-relay configured at the time and had not begun building
anything on top of it. When I reboot, the router will complete the boot
process, but will not give me a prompt. When I boot the router ignoring
NVRAM, the prompt comes back. This happened on all my routers connecting to
the frame relay switch (2522), three 2600s and one 2501. I had completed
the OSPF configuration on one router and when I went to configure its
neighbor, the router was hung. While I worked on that router, the other
neighboring routers hung. Again, the recovery process was the same.
Has anyone seen this before? Or have any suggestions?
Thanks in advance,
Jeff Colburn
This archive was generated by hypermail 2.1.4 : Thu May 01 2003 - 13:36:04 GMT-3