From: Tarun Pahuja (tpahuja@hotmail.com)
Date: Sun Apr 20 2003 - 21:38:42 GMT-3
Folks, Is there a show command which can show how policy based routing is
defined on an interface? I used the following commands but never got any
output after configuring PBR on an interface. How do i know PBR is
working? show policy-map aaashow interface interface eth 0 They both gave
be no results. Here is my configuration. Interface eth 0ip address
20.20.20.20 255.255.255.0ip policy route-map aaa route-map aaa permit 10
match ip address 2
set ip precedence 2
set ip next-hop 10.10.10.10 access-list 2 permit any Thanks
------------------------------------------------------------------------
Help STOP SPAM with the new MSN 8 and get 2 months FREE*
This archive was generated by hypermail 2.1.4 : Thu May 01 2003 - 13:35:59 GMT-3