Serial interface method

From: Richard Danu (rdanu@apex3.com)
Date: Fri Apr 18 2003 - 02:44:56 GMT-3

• Next message: Gogi Kadeishvili: "Re: bandwith"
• Previous message: folivore: "Re: DLSW QoS"
• Next in thread: Jay Hennigan: "Re: Serial interface method"
• Maybe reply: Jay Hennigan: "Re: Serial interface method"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hi,
I just installed another serial module in my 4000 series, and with IOS 12.2
I get 2 various "methods" on my serial interfaces.
Is there a way to change the methods from TFTP or Unset to NVRAM? I believe
the method of TFTP is the cause of the annoying intermittent Error Boot TFTP
<ipaddress> messages. "no service config" only works per uptime, and back to
normal after a reload.

Interface IP-Address OK? Method Status
Protocol
Ethernet0 170.1.1.254 YES NVRAM administratively down
down
Ethernet1 192.168.1.3 YES NVRAM administratively down
down
Serial0 unassigned YES TFTP up
up
Serial1 unassigned YES TFTP up
up
Serial2 unassigned YES TFTP up
up
Serial3 unassigned YES TFTP up
up
Serial4 unassigned YES unset up
up
Serial5 unassigned YES unset up
up
Serial6 unassigned YES unset down
down
Serial7 unassigned YES unset down
down

Thanks,
Richard Danu

• Next message: Gogi Kadeishvili: "Re: bandwith"
• Previous message: folivore: "Re: DLSW QoS"
• Next in thread: Jay Hennigan: "Re: Serial interface method"
• Maybe reply: Jay Hennigan: "Re: Serial interface method"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu May 01 2003 - 13:35:57 GMT-3