From: Ahmed Hassan (ahmed_hassan@rayatelecom.net)
Date: Sun Apr 13 2003 - 13:11:19 GMT-3
Hi ,
By default cisco use priority queue for queue No 0, it will never go to the to all other queues
unless queue have been empty, so if want to use priority queue for queue 1,2 instead of using queue round robin method use this command to make queue 1,2 work as priority before any other queue ;
best regards
*************************************
Ahmed Hassan El-shinnawy
Network Planning and configuration Engineer
Raya Telecom
ahmed_hassan@rayatelecom.net
*************************************
CONFIDENTIAL & DISCLAIMER NOTICE
The information contained in this message is confidential and is intended for the addressee(s) only. If you have received this message in error or there are any problems please notify the originator immediately. The unauthorized use, disclosure, copying or alteration of this message is strictly forbidden. Raya Holding will not be liable for direct, special, indirect or consequential damages arising from alteration of the contents of this message by a third party or as a result of any malicious code or virus being passed on.
Views expressed in this communication are not necessarily those of the Raya Holding.
If you have received this message in error, please notify the sender immediately by email, facsimile or telephone and return and/or destroy the original message.
-----Original Message-----
From: Jaksec, Nick [mailto:Nick.Jaksec@acs-inc.com]
Sent: Sunday, April 13, 2003 3:59 PM
To: 'ccielab@groupstudy.com'
Subject: Custom Queuing question
What does the command "queue-list 1 lowest-custom 2" do? I cannot find on
Cisco's website what the "lowest-custom" is used for. Any help would be
appreciated, thanks !
This archive was generated by hypermail 2.1.4 : Thu May 01 2003 - 13:35:52 GMT-3