From: Brett Lewis (brett_lewis_666@msn.com)
Date: Tue Apr 08 2003 - 06:29:34 GMT-3
Hi,
You should enter the command as:
access-list 101 permit tcp any any time-range TimeTest eq 23
but it will show up in the config as:
access-list 101 permit tcp any any eq telnet time-range TimeTest
hope this helps
Brett Lewis
>From: Jason Wydra <jasonwydra@yahoo.com>
>Reply-To: Jason Wydra <jasonwydra@yahoo.com>
>To: ccielab@groupstudy.com
>Subject: Time-Range option for ACL missing
>Date: Mon, 7 Apr 2003 23:11:10 -0700 (PDT)
>
>Here is my IOS:
>
>IOS (tm) C2600 Software (C2600-JS-M), Version 12.0(9), RELEASE SOFTWARE
>(fc1)
>
>I'm rrying to impliment a time-range for my ACL. The time-range option is
>nowhere to be found. I should be able to input it after the following
>config below. Has anyone seen this? I can't find a bug on CCO.
>
>Thanks,
>
>r8(config)#access-list 101 permit tcp any any eq 23 time-range ?
>
>^
>% Invalid input detected at '^' marker.
>
>
>r8(config)#access-list 101 permit tcp any any eq 23 ?
> ack Match on the ACK bit
> eq Match only packets on a given port number
> established Match established connections
> fin Match on the FIN bit
> gt Match only packets with a greater port number
> log Log matches against this entry
> log-input Log matches against this entry, including input interface
> lt Match only packets with a lower port number
> neq Match only packets not on a given port number
> precedence Match packets with given precedence value
> psh Match on the PSH bit
> range Match only packets in the range of port numbers
> rst Match on the RST bit
> syn Match on the SYN bit
> tos Match packets with given TOS value
> urg Match on the URG bit
> <cr>
>
>
>
>---------------------------------
>Do you Yahoo!?
>Yahoo! Tax Center - File online, calculators, forms, and more
This archive was generated by hypermail 2.1.4 : Thu May 01 2003 - 13:35:49 GMT-3