From: pita40 (pita40@hotmail.com)
Date: Sun Apr 06 2003 - 22:28:40 GMT-3
Hello,
Are these two command necessary when you
configure busy-message?
service hide-telnet-addresses
ip host r2511 192.168.0.2
thanks
P
----- Original Message -----
From: "Tony Schaffran" <tschaffran@cconlinelabs.com>
To: "'Jeff Szeto'" <jytszeto@hotmail.com>; <ccielab@groupstudy.com>
Sent: Sunday, April 06, 2003 8:58 AM
Subject: RE: Can't make busy-message work
> How many VTY ports are configured? How many telnet sessions did you
> open? You will not see the busy message until all of the VTY's are in
> use.
>
>
> Tony Schaffran
> Network Analyst
> CCIE #11071
> CCNP, CCNA, CCDA,
> NNCDS, NNCSS, CNE, MCSE
>
> www.cconlinelabs.com
> Your #1 choice for online Cisco rack rentals.
>
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
> Jeff Szeto
> Sent: Sunday, April 06, 2003 4:48 AM
> To: ccielab@groupstudy.com
> Subject: Can't make busy-message work
>
> Hi Group,
>
> I have tried examples in the archives but can't make it work.
>
> Here is the config:
>
> service hide-telnet-addresses
> ip host r2511 192.168.0.2
>
> busy-message r2511 ^C Busy-message for 2511 ^C
>
> The output:
>
> 2511b#telnet r2511
>
> User Access Verification
>
> Password:
> Password:
> Password:
> % Bad passwords
>
> 2511b#
>
> What is wrong with the config?
>
> Thank you in advance.
>
> Regards,
>
> Jeff
This archive was generated by hypermail 2.1.4 : Thu May 01 2003 - 13:35:47 GMT-3