From: istong@stong.org
Date: Sat Apr 05 2003 - 13:20:07 GMT-3
You will need to configure the LS100 for PVC's or SVC's. I mention
that only because you stated you are trying to use the default config
on the switch. The ATM switch needs to know where to send cells it
receives (much like a routing table on a router). If you need
assistance with that config just let me know what you want to setup
and what you want for vpi/vci values etc.
Thanks,
Ian
www.ccie4u.com
Rack Rentals and Lab Scenarios
On 5 Apr 2003 at 15:02, Gareth Bromley wrote:
> > On the 4500, did you configure "atm clock internal" as well as "loopback
> > diagnostic". This should create a soft loopback that will bring up the
> > interface. If not, you have a bad card.
> Did the above (many thanks for pointing that out) and all is ok on the 4500M
> side of things.
>
> So it cant be cable, and it dont look like cards either end, so it must be
> config issue(s) at one or both of the ends?
>
> Any ideas?
>
> Cheers
>
> Gareth
This archive was generated by hypermail 2.1.4 : Thu May 01 2003 - 13:35:47 GMT-3