From: Charles T. Alexander (charles.t.alexander@verizon.net)
Date: Wed Apr 02 2003 - 19:03:06 GMT-3
I just bought another 2501. When I go to boot it stops at
Would you like to enter the initial configuration dialog? [yes]:
I enter y or n and it goes no where. Any suggestions
----------------------------
System Bootstrap, Version (3.3), SOFTWARE
Copyright (c) 1986-1993 by cisco Systems
2500 processor with 16384 Kbytes of main memory
Booting igs-i-l.111-24.bin from Flash address space
F3: 3832048+95972+196092 at 0x3000060
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Cisco Internetwork Operating System Software
IOS (tm) 3000 Software (IGS-I-L), Version 11.1(24), RELEASE SOFTWARE
(fc1)
Copyright (c) 1986-1999 by cisco Systems, Inc.
Compiled Mon 04-Jan-99 19:00 by richv
Image text-base: 0x030206C0, data-base: 0x00001000
cisco 2500 (68030) processor (revision A) with 16384K/2048K bytes of
memory.
Processor board ID 01237984, with hardware revision 00000000
Bridging software.
X.25 software, Version 2.0, NET2, BFE and GOSIP compliant.
Cisco-ET Extended Temperature platform.
1 Ethernet/IEEE 802.3 interface.
2 Serial network interfaces.
32K bytes of non-volatile configuration memory.
8192K bytes of processor board System flash (Read ONLY)
Notice: NVRAM invalid, possibly due to write erase.
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Would you like to enter the initial configuration dialog? [yes]:
This archive was generated by hypermail 2.1.4 : Thu May 01 2003 - 13:35:45 GMT-3