From: Mike Williams (ccie2be@swbell.net)
Date: Fri Mar 28 2003 - 01:52:22 GMT-3
If you have IP routing enabled, you either need to setup a routing
protocol, or use a 0.0.0.0 route. If you don't have IP routing enabled,
use ip default-gateway to establish the gateway for anything outside of
it's subnet. I've never found a good reason to run proxy arp (not to
say good situations don't exist, but I haven't encountered them). If
anything using proxy arp can hide misconfigured subnet masks making some
problems harder to troubleshoot.
Mike W.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Hunt Lee
Sent: Thursday, March 27, 2003 7:17 PM
To: 'OhioHondo'
Cc: 'ccielab@groupstudy.com'
Subject: RE: how to set interface sc0 in 3550 like in 5000?
Hey OhioHondo,
Can I ask what is the purpose of this default route?
I always assume that if the 3550 is in pure L2 (with "no ip routing"),
then the switch can get out to the rest of the network automatically by
proxy-arp.
Or am I completely off?
Regards,
Hunt
-----Original Message-----
From: OhioHondo [mailto:ohiohondo@columbus.rr.com]
Sent: Friday, 28 March 2003 3:08 AM
To: Mike Williams; 'Fan Shan'; 'Ccielab@Groupstudy.Com'
Subject: RE: how to set interface sc0 in 3550 like in 5000?
Don't forget to set a default route also. (ip route 0.0.0.0 0.0.0.0
x.x.x.x)
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Mike Williams
Sent: Thursday, March 27, 2003 10:12 AM
To: 'Fan Shan'; 'Ccielab@Groupstudy.Com'
Subject: RE: how to set interface sc0 in 3550 like in 5000?
Fan,
There isn't an sc0 interface. Assumming your're communicating with the
switch on VLAN 1, just go into VLAN 1 interface and give it an IP
address and do a 'no shut' and you should be able to communicate with
this switch via IP now.
HTH,
Mike W.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Fan Shan
Sent: Thursday, March 27, 2003 4:10 AM
To: Ccielab@Groupstudy.Com
Subject: how to set interface sc0 in 3550 like in 5000?
how to set interface sc0 in 3550 like in 5000?
FanShan
This archive was generated by hypermail 2.1.4 : Sat Apr 05 2003 - 08:51:45 GMT-3